Grindmaster G23-2B Manuel d'utilisateur télécharger pdf (Page 8)

Dispensing Product

To dispense the product, position the cup under the dispensing valve (C)

and lower the dispensing lever (B) (see fig. O).

Adjustments

Consistency Adjustment

1.) Unplug the machine.

2.) Be sure that product in bowl is within proper fill range.(Above the minimum

fill line)

3.) Remove merchandiser.

4.) Change the thickness of the product by turning the screw (D) on the back of

the bowl, as shown on fig. P. Turn the screw clockwise for thinner product or

counterclockwise for thicker product. The indicator gauge (D1), located on

the back of the bowl, shows the degree of adjustment (+/-). (+) = thicker,

(-) = thinner

Note: This (D1) is an indicator gauge only. To adjust consistency, turn screw

on top (D).

Page 8 G & MG Series Granita Machine

(Figure Q)

(Figure P)

Attention: To prevent the product from becoming too thick,

it is necessary to push left “Press To Select Function” and right

“Press To Select Function” keys to cold drink position or to refill

the bowl when the level of the granita inside the bowl is below the

minimum fill line.

Attention: If the machine is turned off at night, with the bowls filled,

or just partially filled, a layer of solid ice may form on the surface due to the

natural separation of the unmixed (non-moving) product. In this case, before

turning the machine back on, remove the layer of superficial ice to prevent

damage to the mixing auger.

(Figure O)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Pas de commentaire

Grindmaster G23-2B Manuel d'utilisateur Page 8